JEEP KJ CHEROKEE CRD

Multi meter reading. The value of the resistor to use is 2.151 k ohms.

Multi meter reading. The value of the resistor to use is 2.151 k ohms.

The value isnt critical providing you are not too far out, as the temperature value is only used to determine if the fuel heater is required. As an example I used a resistor that gave a temperature reading of 140 deg C, this cause a limp type mode (no engine light, but throttle response was limited to 1500rpm)

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>